QC Inspector Electrical & Instrumentation – Libya – Only for Libyan Nationals – Libyanjobs

Job Overview

Functional Duties

Conduct cable glanding training, assess and approve cable glanding/termination personnel qualification.
Review and approve cable jointer/terminator qualification certificates.
Inspection/testing of temporary electrical works, connections to camp facilities as and when required.
Inspect installation of supports prior to cable tray installation.
Inspection of cable tray/conduit installation prior to release for cable laying.
Inspect cable trench for dimensions and sand bedding prior to cable laying and prior to release each layer of cables.
Monitor cable jointing/termination process to ensure manufacturer’s recommendations are followed.
Inspect cable glanding ,termination, dressing etc.
Witness Insulation Resistance/continuity test of cables on the drum, after laying, prior to trench back filling and after termination.
Witness Hi-pot test of cables.
Surveillance during installation of equipment at substation to ensure manufacturer’s recommendations are followed.
Monitor preservation activities of switch gears, transformers, bus ducts and other equipment.
Inspection of switch gear installation for alignment, location etc.
Witness various testing of switchgears including IR, Hi-pot, ductor, operational etc.
Witness various electrical tests as per applicable ITP/vendor docs.
Final inspection of transformers, Switchgears, MCCs and other equipment’s.
Inspect underground earth cable installation, cad weld joints etc prior to trench back filling.
Witness earth loop resistance/continuity test.
Inspection of lightning protection system of each building.
Inspect site routed lighting cable tray installation and release for cable laying.
Inspect installation of distribution boards.
Monitor preservation activities of motors throughout project period.
Witness IR test and /or polarization index test etc as applicable.
Inspect installation of local control stations.
Witness functional test from local control station to Substation, if applicable.
Witness various inspection/testing related to CP system prior to backfilling and after back filling.
Inspect installation of heat tracing circuits and associated components.
Witness inspection/testing related to overhead power distribution/transmission lines.
Inspect each instrument against data sheet prior to release to site for installation.
Witness calibration of each instrument as required by ITP/specifications.
Monitor preservation requirements of instruments and control panels.
Inspect installation/hook up and pressure test of impulse tubing.
Surveillance during installation of equipment at control room to ensure manufacturer’s recommendations are followed.
Inspect installation of various cables including system cables.
Inspect installation of various F&G instruments, control panels.
Witness testing of the F&G circuits and system as applicable.
Witness testing of control panels.
Verify all inspections related each loop components have been carried out as per applicable ITP’s and documented.
Witness loop continuity checking.
Perform initial detailed inspection of certified electrical equipment based on latest IEC 60079-17 table 1,2,3 and IEC 60079-14, or perform visual or close inspection as applicable.
Correct interpretation of equipment labels, IP Rating etc.
Verify IP Rating is maintained.

Minimum Job Requirement

Degree or Diploma in Electrical or Instrumentation Engineering or equivalent. (Diploma in Electrical/Electronics Engineering may be an optional qualification, if the person is with proven track record in instrumentation)
Minimum 7 years experience as E&I QC Inspector.
Should have experience in oil & gas/Petrochemical industry.
Should have previously worked with major EPC contractors or their subcontractors.

For Hazardous Area Electrical Inspections: Should be an experienced person whose training has included instructions on various types of protection and installation practices, IEC 60079-17 and IEC 60079-14. (Evidence of relevant experience and training claimed shall be documented and available). If no such training attended, he should undergo Petrofac in-house training: PEC-RCD-00384, prior to assigning any Ex-Inspections

If you are interested, Requesting you to kindly share the CV to kanimozhi.ramanujam@petrofac.com with us the below requested details.

Total Years of Experience:

Notice Period Required:

Current Location:

Nationality:

Current salary in LYD:

Expected Salary in LYD: